Gentec-EO P-LINK-4 - Manual (Page 12)

Octolink for P-LINK- 4 User’s Manual Revision 1.2 11
2.9 Real Time Measurement
This displays real time measurement in the center of the window.

The detector type and serial number are shown at top left.

The user defined name is displayed at top right.

A reading displayed in red means that a high/low level alarm is activated.
2.10 Graphic
This displays real time measurement in the center of the window.

The detector type and serial number are shown at top left.

The user defined name is displayed at top right.

A reading displayed in red means that an high/low level alarm is activated.
 The time scale is in “hour:minutes:seconds” defined by Windows and cannot be changed.

The graphic contains between 500 and 500 points.

The default sampling rate is 10 Hz.

When an acquisition is running the displayed points are defined by the sampling rate parameters
of the acquisition.

i.e.: 1440 points for 24 hours at 1 point per minute

Double click on X or Y axis to change scales range.
- Auto Y :
This mode adjusts the scale to content.
- Minimum Y / Maximum Y :
Manually enters the scale
- High / Low Levels:
These buttons set the maximum scale to 110% of the High Level and the minimum scale
to 90% of the Low Level.
2.11 Statistics
This displays statistics.

The statistics are calculated at 10 Hz.

The detector type and serial number are shown at top left.

The user defined name is displayed at top right.

A reading displayed in red means that a high/low level alarm is activated.

Refer to P-Link User Manual for details about statistics calculations.
2.12 Channel Configuration
In this window the channels can be configured individually and indicate the associated window ID.

Name:
User defined name

Gain:
Multiplication factor

Offset :
Addition factor

Wavelength:
Select the wavelength, the range depend on detector type.