General Tools and Instruments HWA2005DL - Manual (Page 24)

3)Until the desired Memory Block no. be selected.
Push the " Send Button " ( 3-5, Fig. 1 ) once, the
data in the Memory Block will send out.
During the data send out, the bottom right display will
show the " Sending Data ! " indicator. When data
already send out completely, the bottom right display
will show the Transmit mode " indicator again.
5)Push the " ESC Button " ( 3-3, Fig. 1 ) will exist
the data sending function and return to the normal
display.
Remarks :
@If intend up load the data to the computer,
then should connect the RS232 cable
( optional, model : UPCB-02) and apply the
Data Logger software ( optional, Model :
SW-DL2005 ).
@When sending the data, each time just can
send one Memory Block data out. for example
block 1 data, block 2 data... or block 250 data.
22