General Tools and Instruments DCT2001 - Manual (Page 10)

b. Use the
" up Button ( A Button ) " ( 3-5, Fig. 1 ),
" left Button ( B Button ) " ( 3-6, Fig. 1 )
" down Button ( C Button ) " ( 3-7, Fig. 1 )
to select the desired value of Temperature
Compensation factor.
c. Once the desired value is reached, push the " Temp.
C Button ( D Button ) " ( 3-8, Fig. 1 ) to set the new
value.
5) Select the applicable range, by using the " Range Button
( B Button ) " ( 3-6, Fig. 1 ).
* If the display shows "- - - -", it indicates an overload
condition, select the next higher range.
* If the display shows "_ _ _ _", it indicates an
out-of-range condition, select the next lower range.
6) Immerse the head of " Conductivity/TDS Probe " ( 3-17, Fig. 1 )
into the solution, up to the immersion level.
7) During the measurement, the lower LCD Display will
show the temperature of the solution.
* Push the " 蚓/蚌 Button " ( 3-5, Fig. 1 ) to change
the temperature display unit from " 蚓 to 蚌 "
or " 蚌 to 蚓 ".
4-2 TDS measurement
The operation procedures are same as the above 4-1,
except that push the " CD/TDS " Button ( C Button ) ( 3 -7,
Fig. 1 ), and select the function to the TDS measurement. The
lower display will show the text of " P ".
8