General Tools and Instruments 861 User Manual

Page 5

ANATOMY OF THE DOVETAILER II JIG

DOVETAIL JIG ASSEMBLY

NOTE: Your jig comes fully assembled for use. The addition of the router control knobs aids in the
use of this jig on router tables.

1. For use on a router table, securely screw in the two Router Table Guide Knobs [6] into the holes

provided on the ends of the jig. Always use the Router Table Guide Knobs when using the jig on
a router table.(FIG. 4)

DOVETAIL ROUTER BIT AND BEARINGS

Included bearings are 1/2 in. outside diameter (OD) and 1/4 in. inner diameter (ID). Router sleeves
or bushings can be used in place of the guide bearings as long as they are also 1/2 in. OD.
Included router bit is 14˚ x 1/2 in. Other bits can be substituted provided they have a 1/4 in.
diameter shank have no greater diameter than 17/32 in.

Caution: Keep fingers on control knobs only when using the jig on a router table.

FIG.4

ቢ

– Jig Assembly

ባ

– Depth Plate

– Template Position Rule

ቤ –

Depth Adjuster Plate

– Depth Measuring Working Surface

– Edge Alignment Teeth

ብ

– Template Lock Screws

ቦ

– Two Router Table Guide Knobs

ቧ

– Face Clamp

ቨ

– Face Clamp Thumb Screws

861 Dovetailer II Manual 11P-081711_Layout 1 8/17/11 5:12 PM Page 5