General Pump MKS Repair Manual - Manual (Page 38)

GENERAL PUMP
A member of the Interpump Group
MKS SERIES
Page 38
Position the O-ring (1, fig. 130) in its seat on the oil seal cover, and insert the assembled unit inside the
crankcase in the correct space (1, fig. 131).
Perfectly insert the cover into its seat (1, fig. 132) being careful not to damage the oil seal lip. Fasten the
oil seal cover with 2 M6 x 14 screws (1, fig. 133).
Calibrate the screws using a torque wrench as indicated in paragraph 3. “SCREW CALIBRATION”
Insert the oil seal in its cover (1, fig. 129) using a stopper p/n F27910900.
Ref 300699 Rev B
05-13