General Pump MKS Repair Manual - Manual (Page 16)

GENERAL PUMP
A member of the Interpump Group
MKS SERIES
Page 16
Completely insert the pressure sleeve on the shaft from the opposite side of the PTO (1, fig. 49 and fig. 50).
Pressure sleeve insertion must be done without oil or lubricants.
Insert the sleeve until the external surface (tapered) couples perfectly with the inside of the
bearing. During insertion, be sure that the bearing remains in contact with the shaft shoulder.
Measure the dimension “X” indicated in fig. 51.
Ref 300699 Rev B
05-13