beautypg.com

Ks series, General pump – General Pump KS Owner Manual User Manual

Page 6

background image

The KS pump has been designed to pump fresh filtered

(360 micron max) water at room temperature (104

0

F max).

7.1 Water temperature

The maximum water temperature allowed is 104

0

F.

Nonetheless, for short periods of time it is possible to oper-

ate the pump with a water temperature of 140

0

F. In this

case, we advise to contact the Technical or Customer

Service Department.

7.2 Max. flow rate and pressure values

The performance values indicated in this manual refer to

the maximum performance of the pump. Regardless of the

power used, pressure and maximum RPM values indicat-

ed on the plate may not be exceeded unless

expressly authorized by the Technical

Department or Customer Service Department.

GENERAL PUMP

A member of the Interpump Group

KS SERIES

Page 6

7. INFORMATION ABOUT PUMP USE

7.3 Lowest RPM

Any RPM value different from what is indicated in the

performance table (see Section 5) must be expressly

authorized by the Technical or Customer Service

Department.

7.4 Recommended Lubricant Oil Types

The pump is delivered with lubricant oil compliant with

room temperatures ranging from 32

0

to 86

0

F. Some recom-

mended lubricant types are listed in the table below; these

lubricants are treated with additives in order to increase

corrosion protection and resistance to fatigue. As an alter-

native, Automotive SAE 85W-90 gearing lubricants may

also be used.

6. DIMENSIONS AND WEIGHT (continued)

Figure 2b refers to pump without reducer

MANUFACTURER

TYPE

GENERAL PUMP

SERIES 220

AGIP

AGIP ACER 220

BP

BP ENERGOL HLP 220

CASTROL

MAGNA 220

ELF

ELF POLYTELIS 220

ESSO

TERESSO 220

TEXACO

RANDO HD 220

FINA

FINA CIRKAN 220

MOBIL

MOBIL DTE Oil 88

SHELL

SHELL TELLUS C 220

TOTAL

TOTAL CORTIS 220

Check the oil level dipstick (pos. 3); refill if

necessary. Correct oil level inspection is done with the

pump at room temperature; oil is changed with the pump at

working temperature by removing the plug (pos. 2), fig 3.

Oil inspection and changing is to be carried out as indicat-

ed in Section 11.

Ref 300655 Rev D

09-12