Finish Thompson FMBC3000 Series - Manual (Page 7)

Section 4 - Maintenance
The FMBC-3000 Series was engineered for low maintenance; however, some conditions will cause increased wear on the paddle and/or possible
damage to the unit. Damage caused by corrosives incompatible with the meters materials of construction or abrasive fluids is not covered under
warranty.
• Replace the battery when the low battery indicator (“Batt”) is displayed in the lower right hand corner. Make sure the meter is in “Power Save”
mode (meter is off with nothing displayed on the front panel) before replacing the battery. The program memory is “non-volatile” and will not
erase when replacing the battery. To replace the battery, open the meter enclosure by removing the four Phillips screws from the back of the
meter. The battery is a lithium 3.6 volt, “AA” size. After replacing the battery, be sure the o-ring seal is in place and is in good condition, before
reinstalling the screws.
Section 5 - Warranty
Finish Thompson, Inc (manufacturer) warrants this product to be free of defects in materials and workmanship for a period of one year from date
of purchase by original purchaser. If a warranted defect, which is determined by manufacturer’s inspection, occurs within this period, it will be
repaired or replaced at the manufacturer’s option, provided (1) the product is submitted with proof of purchase date and (2) transportation charges
are prepaid to the manufacturer. Liability under this warranty is expressly limited to repairing or replacing the product or parts thereof and is in
lieu of any other warranties, either expressed or implied. This warranty does apply only to normal wear of the product or components. This war-
ranty does not apply to products or parts broken due to, in whole or in part, accident, overload, abuse, chemical attack, tampering, or alteration.
The manufacturer accepts no responsibility for product damage or personal injuries sustained when the product is modified in any way. If this
warranty does not apply, the purchaser shall bear all cost for labor, material and transportation.
Manufacturer shall not be liable for incidental or consequential damages including, but not limited to process down time, transportation costs,
costs associated with replacement or substitution products, labor costs, product installation or removal costs, or loss of profit. In any and all
events, manufacturer’s liability shall not exceed the purchase price of the product and/or accessories.
Item
Number
Quantity Description Part
Number
2 1 1” BSPP x hose barb adapter, polypropylene 106737
4 1 1” NPT x 1” BSPP coupling, polypropylene 106736
5 1 Discharge nut, polypropylene 106622
6 1 Flow meter adapter, polypropylene 106599
3, 7 1 O-ring, Viton J100991
1 Batch Control Relay 106739
Section 6 - Parts List
Literature ID Number FT08-1016
Part Number 106784