Finish Thompson PFS ATEX VERSION (INCLUDES M6A, M6XA, M10X MOTORS & SPK) - Manual (Page 4)

3
Safety
1. Introduction
This manual contains all the information needed for the correct installation, use and maintenance of your new Finish Thompson
pump. It should be read and understood by all the personnel involved in installation, operating and servicing of the pump before
it is started.
2. Operator Qualification and Training
The personnel in charge of the installation, the operation, and the maintenance of the pump must be qualified and able to per-
form the operations described in this manual. Finish Thompson, Inc. shall not be held responsible for the training level of
personnel and for the fact that they are not fully aware of the contents of this manual.
3. Safety Instructions
FOR YOUR OWN SAFETY
BEFORE using or servicing your pump, please make sure to wear the proper clothing, eye protection and follow standard safety
procedures when handling corrosive or personally harmful materials.
GENERAL DANGER
ALWAYS use a stainless steel pump tube with an explosion proof electric motor or air motor and static protection kit with
grounded discharge hose when pumping or mixing flammable or combustible material.
ALWAYS use and store the pump and motor in an upright position.
NEVER use in pressurized containers.
ALWAYS use a chemically compatible hose rated for the temperature of the product being pumped.
ALWAYS select the proper o-ring material. Improper material selection could lead to swelling and be a possible source of leaks.
This is the responsibility of the end user.
ALWAYS check the pump for leaks on a regular basis. If leaks are noticed, the pump must be repaired or replaced immediately.
ALWAYS clean the pump on a regular basis to avoid any dust buildup greater than 5mm deep.
ALWAYS check compatibility and temperature range of pump with liquids used. A Chemical Resistance and Material Selection
Guide can be downloaded from our website at www.finishthompson.com.
NEVER run dry.
NEVER use with liquids containing solids that can damage the internals (i.e. metal chips) without optional strainer.
ALWAYS flush unit with water after each use.
ALWAYS store unit upright, i.e. motor above pump, and away from corrosive liquids and vapors.
ALWAYS check bearings for signs of overheating, abnormal noise or other signs of premature failure on a daily basis. Bearings
should be replaced at the first sign of failure.
ALWAYS when using an air motor, use an automatic airline lubricator, moisture trap, and filter in the airline before the motor
(use SAE#10 oil in the lubricator). Adjust lubricator to feed one drop of oil per minute of continuous run time. Do not exceed
80 psi (551 kPa) on M6A and 100 psi (689 kPa) on M6XA. Maximum air consumption: M6A = 27 cfm (47 m3/hr),
M6XA = 30 cfm (49.5 m3/hr).
DANGER: POWER SUPPLY
Refer to instructions in this manual.
4. Noise Level
90 db at a distance of 3 feet (approximately 1 meter).
5. Modifications and Spare Parts
Any changes concerning the service of the pump as originally purchased can be executed only after written approval from
Finish Thompson Inc. It is recommended to use only genuine Finish Thompson Inc. spare parts and approved accessories. The
use of non-original spare parts or non-approved accessories will void warranty and removes any responsibility on the manufac-
turer’s behalf for any damage caused to people or things.
6. Cleaning
It is highly recommended to flush pumps with clean water or some other neutralizing fluid compatible with pump materials
when done pumping or when switching chemicals.