Fairbanks FB3000 Kernel Program Operators Manual - Manual (Page 12)

Section 2: Customer Responsibility
04/12 12 51147 Rev. 3
2.2. EQUIPMENT/ COMPONENT CARE
Do not remove power from this unit unless it is performed by the
proper shut down method. Failure to comply with the proper shut
down procedures can result in damage to the hard disk drive or data.
The AC receptacle/outlet shall be located near the instrument and
easily accessible.
Electrical connections other than those specified may not be
performed.
Absolutely no physical, electrical or program modifications other
than selection of standard options and accessories are to be made to
this equipment.
─
Electrical connections other than those specified may not be
performed, and physical alterations (holes, etc.) are not allowed.
The equipment consists of printed circuit assemblies which must be
handled using proper ESD handling procedures.
─
Replacement of individual components is not allowed.
─
Any assemblies which are replaced must be properly packaged in
ESD protective material if they are returned for replacement credit
under a warranty condition.