Darex XPS-16 SCHEMATICS & WORK INSTRUCTIONS - Manual (Page 36)

User Manual Page 36
7. Loosen the 2, 3mm set screws in the top of
the cartridge block that holds the cartridge in
place.
8. Slide the cartridge forward allowing enough
room to remove the drive pulley.
Remove the pulley and pull the cartridge out
through the front of the block.
9. To replace the cartridge, slide into block, but
do not tighten set screws.
10. Slip the drive pulley over the end of the arbor
shaft. It will be necessary to slide the cartridge
forward to allow clearance to do this. Leave
the pulley set screw loose.
11. Take the wheel casting and align the dowel
pins with the holes in the cartridge block. Push
or tap into place. Secure with 4mm screws.
12. Now slide the cartridge all the way forward
until it stops against the wheel casting. Using
a torque wrench, torque the set screws to
6 inch lbs. Do not over tighten.