Alcatel-Lucent IP Touch 610 - Manual (Page 23)

Batteries and chargers
23
6
Other
6.1 Batteries
„ Utilization precautions
Take care not to short the battery contacts on the Battery Pack with metal objects such as coins, keys or paper clips. Shorting
the contacts can cause permanent damage.
The MIPT will need to have its Battery Pack recharged periodically.
„ Autonomy
There are different battery models for your set, each with different capacities.
„ Battery charging level.
In communication : when the battery level is low, the MIPT informs you of this via the battery low icon. A beep indicates that
you have 2 minutes conversation time left.
Not in call: The battery icon is displayed whenever the battery pack charge level is low. The Low Battery message and a loud
beep indicate that the charge level is extremely low. This happens when the user is not in communication. To be able to use
your wireless telephone again, you must recharge the battery pack.
„ Removing and replacing the battery in IP Touch 310 WLAN models
Press the battery latch on the rear of the wireless telephone set. The battery detaches from the telephone. To replace the
battery, insert the battery catch into the bottom of the battery compartment. Press the top of the battery so that it clicks into
position. You should not exert any undue pressure to assemble the battery and telephone.
Type In conversation in standby
Standard 4 80
Extended 6 120
Ultra Extended 8 160
Type charging times
Standard 4
Extended 6
Ultra Extended 8
6.2 Desktop Charger
During the charging, you can use your telephone as usual to make or take calls.
„ Utilization precautions
The desktop charger is designed to charge your IP Touch 310 or 610 WLAN set. A complete charge takes 2, 3 or 4 hours
depending on your battery model.
Do not place anything in the charger other than the MIPT. You might damage the contacts. Bent contacts may hinder correct
MIPT charging.
„ Charging indicator
If the MIPT is turned off, only Charging... will be displayed. The dots will be racing during the charging cycle. It is normal for the
Battery Pack to become warm when charging.
„ Charge Complete
When the MIPT is fully charged, Charge Complete will display.