Elite Screens ChromaFlux (Water Based) - Manual (Page 8)

043014-KY www.elitescreens.com 8
6. Inspect the end result
a. Inspect the screen’s uniformity after painting is completed. If the color is not even throughout the
viewing surface, repeat steps 2-5.
b. If black, thin lines are evident on the viewing surface, repeat steps 2-5 and be sure to hold the nozzle
60cm-70cm from the surface when repainting.
D2. Application of the 3D paint (final coat)
1. You must allow a 24 hour period for drying time of the 2D paint before applying the 3D paint (final
coat).
2. Follow the instructions of the 2D paint to apply the 3D paint (procedure D1).
3. After applying the 3D paint, allow at least 4 hours of drying time before removing all protective
covering and tape. The paint must be dry to the touch.
4. Below is a comparison of how the color of the finished product will look after it has completely dried.
Safety Precautions
A. Be sure that the work area is well ventilated.
B. Always wear protective gear such as gloves, a mask, etc. to avoid any injury, inhalation of the fumes, or
direct contact of the paint on your skin.
C. Should you get paint in your eyes, flush with warm water until all of the paint is removed. Then, seek
medical attention immediately.
D. Make sure that the product is stored out of the reach of children.
E. Harmful if swallowed. If in case the paint is accidentally swallowed, gargle plenty of water and spit it out.
Do not induce vomiting. Seek medical attention immediately after gargling.
F. When seeking medical attention, bring the can of paint with you to show the doctor what you have been
working with.
G. Avoid using sharp objects on the painted area. Do not mark, or write on the viewing surface.
H. For more detailed information, please refer to the EliteScreens "Material Safety Data Sheet."
I. Do not dump left over paint down sewage drains, or do not flush down the toilet. Dispose of the paint
properly by taking what’s left over to a HAZMAT facility.
2D paint (base paint) 3D paint (face paint)