Teledyne AX300 - Medical application oxygen analyzer - Manual (Page 15)

Portable Oxygen Analyzer Operating Instructions
Teledyne Analytical Instruments
7
2. Plug one end of the coiled cable into the receptacle on the back of the
R17MED sensor and secure it in place with the capture nut located at the
base of the connector. See Figure 2-1.
Figure 2-1: Installing the R17MED Sensor
3. Plug the other end of the cable into the receptacle located on the side of the
unit and secure it using the capture nut. See Figure 2-2.
Figure 2-2: Sensor Cable Connection to Analyzer
Note: Cable shown is for illustration purposes only.
Note: Do not use the plastic flow diverter with the R17MED sensor when the sensor is
used for diffusion sampling (such as with oxygen tents, incubators, etc.). When