Teledyne 3190Z - Zirconium oxide trace oxygen analyzer - Manual (Page 25)

Trace Oxygen Analyzer Operation
Teledyne Analytical Instruments 17
Operation
4.1 Introduction
Once the analyzer has been mounted, the gas lines connected, and
the electrical connections made, the analyzer can be configured for your
application. This involves setting the system parameters as follows:
• Defining the user-selectable analysis ranges
• Setting alarm set-points.
• Calibrating the instrument
All of these functions are performed via the front panel controls,
shown in Figure 4-1.
Analyzing a gas sample for the percent oxygen level through the
cell block is the default mode of operation. The analyzer is monitoring
the oxygen level as long as no front panel buttons have been pressed.
Figure 4-1: Front Panel Controls and Indicators