Teledyne 2240 – Portable Handheld Hydrogen Leak Detector, 2nd generation - Manual (Page 6)

Page 11 of 26 M2240 R0
Figure 3 – Analog Output Port and Plug
4. Preparing 2240 for Operation
• Ensure that all items ordered are present. Refer to the 2240
carrying case components shown in section 3.
• 2240 is shipped with its battery separate from the Hand
Held Controller. The battery is not charged when
shipped. To charge the battery, please refer to Section 8.
• After charging the 2240 Battery, insert it into the base
of the Controller.
• Remove the Controller from the carrying case.
• Remove the battery door from the back of the Controller
by pressing inward while lifting up on the battery door
release tab.
• Use a coin to carefully depress/lift the release tab.
• Insert the battery into the Hand Held Controller. The
battery connections are at the top of the unit and will mate
with the controller body in only one orientation.
• Replace the Battery Door.
External Power
Connection
Serial Data
Analog Output Port
Page 12 of 26 M2240 R0
Using the Wand Assembly
The Wand Assembly enables the operator to extend his or
her reach and sense for hydrogen gas in hard-to-access areas.
The Wand Assembly uses the Sensor Module attached to the
Controller.
To attach the Sensor Module to the Wand Assembly:
• Verify that power is OFF. See section 5.
• Remove the Sensor Module from the Controller by
pressing and holding down the release tab located on the
back of the controller body. The Sensor Module will
unlatch.
• Gently pull the Sensor Module away from the Controller
body.
• Position the Sensor Module above the Wand Assembly
such that the release tab on the back of the Wand
Assembly Receiver is aligned with the locking detent on
the Sensor Module.
• Gently push the Sensor Module into the Wand Assembly.
• Position the Wand Connector on the end of the coiled cable
of the Wand Assembly such that the release tab on the
back of the Controller is aligned with the locking detent on
the body of the Wand Assembly.
• Gently insert the Wand Connector on the end of the coiled
cable into the Controller.
• Verify that the Wand Connector is fully seated and the
locking tab latches into place.
To remove the Wand Assembly:
• Verify that power is OFF. See section 5.
• Press and hold down the release tab located on the back on
the Controller. This will unlatch the Wand Connector.
• Place a finger from the opposite hand through the loop in
the Wand Connector Pull Strap and gently pull the Wand
Connector away from the Controller. Do not pull on the
cable as this may damage the Wand Assembly.