Fulton Caliber (CAL) SOLA Gateways - Manual (Page 13)

__________________________________________________________
_____________________________________________________________________________________
Questions? Call (315) 298-5121 or visit us online at www.fulton.com
©The Fulton Companies 2013
Supplement SOLA-IOM-2013-0220
grab a cup of coffee. Once the ProtoNode has restarted, the new configuration files will be
ready to use.
5. Disconnect your Ethernet cable, and don’t forget to re-enable your wireless if you shut it down.
If you already had a static IP address loaded on your computer, restore it now or you might have
trouble connecting to the internet later.
6. Lonworks Exception: After new configuration files have been loaded into the Lonworks module,
it will most likely have to be re-commissioned into the Lonworks Network.
Return to Table of Contents
Connection Help
Setting the Static IP Address
For most windows users following these steps will allow you to temporarily set the static IP address
for connection to the ProtoNode module:
1. Click the Start Menu and go to Control Panel.
2. Double Left Click on the Network Connections Icon.
3. Right Click on the Local Area Connection Icon and select Properties.
4. Highlight Internet Protocol (TCP/IP) and press the Properties Button.
5. Select “Use the following IP Address” option.
6. In the IP address box input 192.168.1.101
7. In the Subnet mask input 255.255.255.0
8. Leave the Default gateway blank.
9. Press the OK Button on the two properties windows.
To remove the static IP Address when finished, follow steps 1 through 4. At step 5 Select “Obtain IP
Address Automatically” instead.
To restore a previous static IP Address follow all steps 1 through 9, substituting your static IP
information at steps 6 and 7.
Return to Table of Contents