Fulton Caliber (CAL) SOLA Gateways - Manual (Page 10)

__________________________________________________________
_____________________________________________________________________________________
Questions? Call (315) 298-5121 or visit us online at www.fulton.com
©The Fulton Companies 2013
Supplement SOLA-IOM-2013-0220
Module Service Pin: Lonworks Module Only
The service pin is used during the commissioning process on a Lonworks network. In order to use the
service pin on this module you will need a small screwdriver, small enough to fit into the service pin
hole. Put the screwdriver into the service pin hole and tilt gently forward towards the Lonworks 2 pin
connector. See Fig. 1.
Return to Table of Contents