Asus P/E-P55T2P4D - Manual (Page 29)

P/E-P55T2P4D User’s Manual 23
III. INSTALLATION
(Connectors)
III. INST
ALLA
TION
5. Floppy drive connector (34-pin block )
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two plugs
on the other end to the floppy drives.
Floppy Drive Connector
Pin 1
6. Primary / Secondary IDE connectors (Two 40-pin Block)
This connector supports the provided IDE hard disk ribbon cable. After con-
necting the single end to the board, connect the two plugs at the other end to
your hard disk(s). If you install two hard disks, you must configure the second
drive to Slave mode by setting its jumpers accordingly. Please refer to the
documentation of your hard disk for the jumper settings. You may also config-
ure two hard disks to be both Masters using one ribbon cable on the primary
IDE connector and another ribbon cable on the secondary IDE connector.
Primary IDE Connector
Secondary IDE Connector
Pin 1