PSA LIF5800RL User Manual

Page 7

5. HOW TO REMOVE SMOKE ALARM FROM BASE PLATE

5.1 Look for ‘SLIDE TO REMOVE’.
5.2 Remove Tamper Locking Screw if installed.

5.3 Push firmly towards arrow until smoke alarm unhinges from base plate.

5.4 To re-install smoke alarm follow FIGURE 2 procedure 1 to 3. See page 9.

6. INSTALLATION

WARNING: THIS SMOKE ALARM MUST BE INSTALLED BY

QUALIFIED (LICENSED) ELECTRICIANS ONLY.

6.1

Wiring Instructions

6.1.1 In the interests of safety, this smoke alarm and all wiring must be installed by

a licensed electrician in accordance with the relevant requirements of the
SAA Wiring Rules - AS3000.

6.1.2 For model LIF5800RL; Connecting the smoke alarm on the base plate will

activate the lithium battery. Please note, the long absence of mains power
may damage the rechargeable battery. Warranty is void if the battery is dam-
aged. If the mains power is turned off for a long period of time, for example,
if the building is not occupied, disconnect the smoke alarm from the base
plate. When mains power is turned on, ensure the smoke alarm is then con-
nected to the base plate. The battery may be low in new smoke alarms,
please allow up to 8 hours for the battery to fully charge. Smoke alarms may
chirp until the battery is fully charged. When recharging do not press Test or
Hush button.

1398-7208-03:_ 2012.6.13 4:24 PM Page 5

This manual is related to the following products:

LIF5800