PROLiNK MH8241 - Manual (Page 49)

49
- Disable: no Healthy Check function,
if without “Time Server” exist, this function will disable automatically
Healthy Check can be set up to test 3 different destination IP, in order to avoid
Wrong operation. ( in case destination server fail)
WAN TYPE
Three kinds of
WAN types to let you select on each WAN port:
1.
[Dynamic IP]
. connect to CABLE MODEM.
Obtain an IP address from ISP automatically.
Usually it's used to connect CABLE modem. You won't need to assign IP
Address, the Broadband Router will get the IP address for you
automatically.
2.
[PPPoE] (Gateway / Basic NAT Mode only)
. connect to Dial Up DSL
Some ISPs require use of PPPoE to connect to their service.
Connect to ISP via dial-up connecting, ISP will assign a legal IP to you after
the user Id and password had been passed when the connection is made
(The user Id and password here are provided by your ISP.)
3.
[Static IP]
. connect to Leased DSL
ISP assigns you a static IP address.
When used the leased line of ADSL. ISP will provide you the relative IP,
Subnet Mask, Gateway and DNS. You need to indicate the static IP
manually.
SCHEDULE
This function allow you to control each WAN port link up/down time by
daily/weekly
Start Time (hh: mm)
End Time( hh: mm)
Using 00 ~23 to indicate Hours.
Example 17:00 means 05:00 PM
Weekly: choose by day
Note: When enable SCHEDULE function, the Line will up/down following
the timer set, no matter DOD function is enable or not.
WAN SPEED: you need to enter speed of each WAN port (K bps)
Otherwise ROUTER
will not work properly in
Load Balance: Traffic Mode
Bandwidth Usage Control
WAN Link Mode:
You can choose WAN port work mode with ADSL modem
Auto Sense
10Mbps Half Duplex