PROLiNK WN2000 Wireless-N User Manual - Manual (Page 32)

- 26 -
Advanced Tab
Wireless mode Here supports 2.4G (included 802.11b/g/n) wireless mode.
Enable TX Burst Check to enable this function. This function enables the
adapter to deliver better throughput during a period of
time, it only takes effect when connecting with the AP
that supports this function.
Enable TCP
Window Size Check to increase the transmission quality. The large TCP
window size the better performance.
Fast Roaming at
dBm Check to set the roaming interval, fast to roaming, setup
by transmits power. Default setting is -70dBm.
Show
Authentication
Status Dialog When you connect AP with authentication, choose
whether show "Authentication Status Dialog" or not.
Authentication Status Dialog displays the process about
802.1x authentications.
Enable CCX
(Cisco Compatible
extensions) Check to enable the CCX function.
• Turn on CCKM.
• Enable Radio Measurements: Check to enable the
Radio measurement function.
• Non-Serving Measurements limit: User can set channel
measurement every 0~2000 milliseconds. Default is set
to 250 milliseconds.