American Dynamics ADCC1100 - Manual (Page 48)

42
ADCC1100
Reading Quicksite Settings on a Smart Card
An operator with administrator privileges can check and configure the Quicksite
settings on individual smart cards. This ensures that all system operators have the
correct configurations on their smart cards.
1. Press the PROGRAM MODE tab key.
2. Press the NEXT soft key.
3. Ensure that the MP48 MODE/AD1024 MODE/QUICKSITE MODE soft key is set
to Quicksite mode.
4. Press the PARTITION QUICKSITE soft key.
5. Press the QUICKSITE CONFIG soft key. The Quicksite configuration menu is
displayed (figure 5.2), with the settings for the currently inserted smart card
shown.
6. Press the READ SC soft key.
7. The keyboard will display the message "Please Replace Smart Card". Insert the
smart card to be read and the display will change showing the information on the
new smart card.
Copying Quicksite Settings from One Smart Card to Another
An operator with administrator privileges can copy Quicksite settings to individual smart
cards. This ensures that all system operators have the correct configurations on their
smart cards. A user without sufficient privileges cannot change their own Quicksite
settings.
1. Press the PROGRAM MODE tab key.
2. Press the NEXT soft key.
3. Ensure that the MP48 MODE/AD1024 MODE/QUICKSITE MODE soft key is set
to Quicksite mode.
4. Press the PARTITION QUICKSITE soft key.
5. Press the QUICKSITE CONFIG soft key. The Quicksite configuration menu is
displayed (figure 5.2), with the settings for the currently inserted smart card
shown.
6. If the Quicksite settings to be copied are on the card currently inserted into the
keyboard, go to step 8.
7. If the Quicksite settings to be copied are on a different card, insert the card and
press the READ SC soft key.
8. Press the PROG SC soft key. At the "Please Replace Smart Card" prompt, insert
the smart card to which you want to copy the Quicksite settings and wait until the
process is complete.