Configuring satellite sites, Keyboard installation and operation – American Dynamics ADCC1100 User Manual

Page 47

Keyboard Installation and Operation

Program Mode

Macros

Operator

Site

Home

Down

Read

Prog

Site

Down

Start
Cam

End

Cam

Start

End

1
2
3
4
5
6
7
8
9

257
512

1024
2315
3000
5100
6500
- - - -

256
500
675

1200
2540
3100
5250
6550

- - - -

Figure 5.2: Quicksite Configuration Menu

5. Press the QUICKSITE CONFIG soft key. The Quicksite configuration menu is

displayed (figure 5.2).

In this menu, configure the different sites in the system using the following procedures:

Configuring Satellite Sites

To configure the settings for satellite sites:

1. Using the SITE UP and SITE DOWN soft keys, move the arrow cursor to the site

which is to edited.

2. To specify the pseudo number of the first camera at this site, use the numerical

keys to enter the required camera number and press the START CAM soft key.

3. To specify the pseudo number of the last camera at this site, use the numerical

keys to enter the required camera number and press the END CAM soft key.
Important Note: The pseudo numbers programmed to the keyboard must match

the pseudo numbers programmed to each individual matrix site.

4. Repeat steps 1 to 3 to configure each satellite site. Up to nine sites can be

included. Camera numbers from site to site do not need to be sequential (as

illustrated in the figure above), but the camera numbers cannot overlap.
To clear a site, move the cursor to the required site, enter a 0 on the numerical

keypad and press either the START CAM or END CAM soft key.

5. Once the camera numbering has been configured, it is necessary to specify a

home site for the keyboard in use. The home site is the site to which the

keyboard is directly connected.
To specify the keyboard's home site, use the HOME UP and HOME DOWN soft

keys to move the H marker to the required site.

6. To store the settings to a smart card, press the PROG SC soft key.

7. The keyboard will display the message "Please Replace Smart Card". Insert the

smart card to be programmed and wait until the process is completed.