Bosch DID09T950 Edelstahl 90 cm breit Deckenlüftung - Manual (Page 18)

18
Operating procedure
To activate the functions simply tap
the buttons. If the buttons are pressed for
too long, no function is activated.
The most effective method of
removing vapours produced during
cooking is to:
‰
Switch the ventilator ON
as soon as you begin cooking.
‰ Switch the ventilator OFF
a few minutes after you have finished
cooking.
Acoustic signal
‰
When a push button is pressed, this is
verified by an acoustic signal.
Switching the fan ON
‰
Press the + Push button
Setting the required fan speed
‰
Press the + Push button
The fan speed is increased by one
step.
‰ Press the - Push button
The fan speed is reduced by one
step.
Switching the fan OFF
‰
Press the O Push button
the displayed goes out shortly
afterwards.
Or
‰ Keep pressed the – push button until
the fan switches off.
The displayed goes out shortly
afterwards.
Intensive Setting:
Maximum power is obtained at the
intensive setting. It is only required for
short intervals.
‰
Keep pressed the + button until a
appears in the display.
‰ If the intensive setting is not cancelled
by hand, the fan will automatically
switch back to step after 10
minutes.
Fan follow on:
‰
Press the . button
The fan continues to run at step for
10 minutes and at the same time a
dot flashes in the display. After this
period the fan switches off
automatically.
Lighting:
‰
The light can be switched on at any
time, even though the fan is switched
on.
Remote control:
The remote control is set up by
the manufacturer. If the remote
control is not controlling motor or
light nearby the cooker hood,
please do the following.
Set up of the remote control.
Keep pressing the “+” button of
the remote control and then connect the
cooker hood, to confirm that the remote
control has been recognized a long beep
is issued. If you do not hear the acoustic
signal within 30 seconds, please repeat
the steps as described.
Functions of the remote control.
The +, -, and Light Push button have
the same functions as on the controls of
the hood.
The : Push button has the same
function as the .
Light
It switches
motor off
Timer
It switches motor on
and increases the
speeds
Speeds
Indicator
It decreases the
speeds