Allied Telesis AT-AR256E - Manual (Page 13)

- 13 -
Figure 5 (PPPoA Connection Setup)
To complete the connection, you must now click the Apply button. The Apply button will
temporarily save this connection. To make the change permanent, you need to click on Save
Settings (at the side of the page). At the system commands page, click on Save All.
4.4.1.3 PPPoE Connection Setup
PPPoE is also known as RFC 2516. It is a method of encapsulating PPP packets over Ethernet.
PPP or Point-to-Point Protocol is a method of establishing a network connection/session between
network hosts. It usually provides a mechanism for authenticating users.
To configure the gateway for PPPoE, click on Setup and then click on
New Connection . The
default PPPoE connection setup is displayed. At the Type field select PPPoE and the PPPoE
connection setup page is displayed; Figure 6 illustrates a typical PPPoE configuration. Give your
PPPoE connection a unique name; the name must not have spaces and cannot begin with
numbers. In this case, the unique name is called
PPPoE1 . Select the encapsulation type (LLC
or VC); if you are not sure, just use the default mode. Select the VPI and VCI settings; your
ADSL Provider or ISP will supply these; in this case, the ADSL Provider is using
0,100 . Also
select the Quality of Service (QoS); leave the default value if you are unsure or the ISP did not
provide this information.
The following is a description of the different options:
a. Username: The username for the PPPoE access; this is provided by your ADSL
Provider or ISP.
b. Password: The password for the PPPoE access; this is provided by your ADSL
Provider or ISP.
c. On-Demand: Enables on-demand mode. The connection will disconnect if no activity
is detected after the specified idle timeout value.
d. Idle Timeout: Specifies that PPPoE connection should disconnect if the link has no
activity detected for n seconds. This field is used in conjunction with the On-Demand
feature. To ensure that the link is always active, enter a 0 in this field.