Alliance Laundry Systems 105 - Manual (Page 53)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT M414545 51
Section V
Operating Instructions
ALWAYS FOLLOW THE FABRIC CARE
INSTRUCTIONS SUPPLIED BY THE GARMENT
MANUFACTURER.
The following steps outline the procedure for operating a
tumbler through a complete drying cycle.
MANUAL DUAL TIMER
TUMBLER
1. Energize the electrical circuit to the tumbler at the
disconnect switch or the circuit breaker.
2. Open the lint panel and check for any accumulated
lint on lint screen. Close panel tightly against tumbler
frame and lock panel securely.
3. Open the loading door and load the cylinder with
laundry. Overloading will result in excessive drying
time, wrinkled laundry, and wear to cylinder
bearings.
4. Set the TEMPERATURE selector at HIGH (cotton
load) (190°F, 88°C) , MEDIUM (mixed load) (162°F,
72°C), LOW (Permanent Press) (140°F, 60°C), or
anywhere between these settings. The type of fabric
being dried will determine the setting.
5. Set the DRYING selector for the number of minutes
desired.
6. Set the COOLING selector for the number of
minutes desired.
7. Press the PUSH-TO-START button in and hold it in
for approximately three seconds. This starts the
tumbler cycle.
IMPORTANT: If the loading door is opened during
the cycle, the heating system will shut off and the
motor will stop. To restart the cycle, door must be
closed and the PUSH-TO-START button must be
pressed in and held for approximately three seconds.
8. When the cycle is completed, open door and remove
the laundry.
To reduce the risk of fire:
• DO NOT DRY articles containing foam rubber
or similarly textured rubberlike materials.
• DO NOT DRY plastics, anything containing
wax or chemicals such as mops and
cleaning cloths, or anything dry-cleaned at
home with a dry-cleaning solvent.
• DO NOT TUMBLE fiberglass curtains and
draperies unless the label says it can be
done. If they are dried, wipe out the cylinder
with a damp cloth to remove particles of
fiberglass.
W076
WARNING
To reduce the risk of serious injury, open
tumbler door and allow cylinder to stop
before cleaning lint screen. Do not operate
without lint panel in place.
W077
WARNING