Alliance Laundry Systems 105 - Manual (Page 60)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
58 M414545
B. Time Dry and No Heat
After fabric selection, press the TIME pad. Refer
to Figure 29.
TIME DRY Pads
Figure 29
A preset drying time, “Td:**” will replace
“A0:00” in the display. This time can be changed
by pressing the MORE or LESS pads. For 1
minute changes, press pad and release. For 5
minute changes, press pad and hold. Maximum
drying time allowed is 60 minutes.
Table 10
AC:** will be displayed when tumbler is in Auto
Cool Down. Typical cool down times for fabric
selections are preset. Refer to Table 9. The cool
down time can only be altered before cycle is
started. To alter cool down time press the COOL
DOWN pad and then press the MORE or LESS
pad (when cool down time is altered, TC:** will
be displayed). For 1 minute changes, press pad
and release. For 5 minute changes, press pad and
hold. Cooling time can be from 1 to 39 minutes.
To return to the Auto Cool Down, press MORE or
LESS pad until AC:** is displayed.
To start the cycle, press START. The total drying
time plus cool down time will display. During the
cycle, remaining time displays.
NO HEAT is a time dry cycle only. When NO
HEAT is pressed, a 20 minute preset time will
display. This can be changed from 1 minute to 60
minutes by pressing the MORE or LESS pads
before pressing START. The COOL DOWN pad
does not work in NO HEAT cycles.
C. Special Cycle Mode
This allows the user to select the number of times
the tumbler will cycle from heat-on to heat-off. To
enter the Special Cycle Mode, press the
SPECIAL CYCLE pad after selecting a cycle.
The display will read “SC:**”. “**” is the number
of times the tumbler will cycle from heat-on to
heat-off. This number can be changed by pressing
the MORE or LESS pads. For increments of 1,
press pad and release. For increments of 5, press
pad and hold for 3 seconds. Range is from 1-99.
Press the START pad and the number shown after
“SC:” is the number of cycles selected, the
number will decrease as each cycle is completed.
The default cool-down cycle for the Special Cycle
Mode is Automatic Cool Down.
NOTE: Since there is only 60 minutes of cycle time,
any cycles not completed within 60 minutes will be
skipped.
NOTE: Unlike the Time Dry mode and Automatic
mode, the regulating temperature in the Special Cycle
Mode has a range of 80°F to 180°F for all heat cycles.
Cycles Preset Time Range
COTTONS 35 Min 1-60 Min.
PERM PRESS 20 Min 1-60 Min.
MIXED 15 Min 1-60 Min.
DELICATES 30 Min 1-60 Min.
NO HEAT 20 Min. 1-60 Min.