Perma Pure Micro-GASS UG-1212 - Manual (Page 15)

Dryer Element Replacement
Under the operating conditions specified, the Nafion
® dryer element should last for several
years. However, if the element becomes wet, clogged, or dirty it may require replacement.
Disconnect the system power source before continuing
1. Remove four (4) screws from filter housing flange.
Remove these screws
2. Open cover and lift control panel to gain access to the system components.
3. Disconnect the tube running from the pump to the dryer exhaust at the dryer end.
Remove tube at
this location
4. Using a 3/32” Allen wrench, remove the dryer exhaust fitting from the dryer
3/32” Allen socket for
fitting removal
5. Disconnect both tubes from the opposite end of the dryer.
6. Using a 3/32” Allen wrench, remove the side fitting at the opposite end of the dryer to
allow it to slip through the heated section.
15