Mechanical connections – Perma Pure Micro-GASS UG-1212 User Manual
Page 12
Figure 3 – Electrical Connections
Mechanical Connections
All connections to the MicroGASS system are intended to be made with Teflon or
other suitable plastic tubing
Wet Sample Gas Inlet -
Compression fitting for ¼″ OD Tubing. To be connected to the
sample gas source via a heat traced line to prevent condensation of the sample gas. Once
the heated sample line is installed, the heated line inlet fitting can be shrunk into place
permanently.
Heat shrink
sealing fitting
Figure 4 – Heated Line Connection
Calibration Gas Inlet -
Compression fitting for ¼″ OD Tubing. To be connected to the
sample calibration gas source. Do not exceed 30 psi. Port must be capped when not in use
Dry Sample Gas Outlet -
Compression fitting for ¼″ OD Tubing. To be connected to
analyzer’s inlet port
12