American Dryer Corp. AD-75 User Manual

Page 23

F. ELECTRICAL INFORMATION

1. ELECTRICAL REQUIREMENTS

It is your responsibility to have all electrical connections made by a properly licensed and

competent electrician to assure that the electrical installation is adequate and conforms with local

and state regulations or codes. In the absence of such codes, ALL electrical connections, material,

and workmanship must conform to the applicable requirements of the National Electrical Code

ANSI/NFPA NO.70-LATEST EDITION..

IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements

stipulated in this manual can result in personal injury or component failure.

NOTE: Component failure due to improper installation will VOID THE WARRANTY.

Each dryer should be connected to an independently protected branch circuit. The dryer must be
connected with copper wire only. DO NOT use aluminum wire which could cause a fire hazard.

The copper conductor wire/cable must be of proper ampicity and insulation in accordance with
electric codes for making all service connections.

NOTE: The use of aluminum wire will VOID THE WARRANTY.

IMPORTANT: A separate circuit servicing each dryer must be provided.