Pach and Company AeGIS 9000 Series Manual User Manual

Page 35

FUNCTION CODE

LOCAL PROGRAMMING

• If the PBX is enabled, the system

will not dial a PBX extension.

OPEN DOOR 1 AND DOOR 2

NUMBER (REMOTE ACCESS
NUMBER) OR CCTV SWITCH

(Default setting is 9 to unlock

relay 1 (door 1) or 8 to unlock

relay 2 (door 2) or

CCTV is 6 to Open and 7 to close

the camera)

Step 4

Enter the PBX number to get the outside line (up to 3-digit), then press #, the
display shows

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 43 then press # and the display shows

Step 3

Enter (0-9) then press #,

Step 4

Enter (0-9) then press # the display shows

Pach and Company

Chapter 3

Page 27

AeGIS 9000 Series

PROGRAMMING

PBX Area No.
_ _ _

SELECT PROGRAM
ENTER: _ _ PRESS #

Open Door1No(0-9)
ENTER: _ PRESS #

If relay 2 (door 2) is set for Mode 1
(door control), the display shows

proceed to step 4

if the number is already used the
display shows

return to step 3

if relay 2 is set for Mode 4 (CCTV
Switch), the display shows

proceed to step 4

if the number is already used the
display shows

return to step 3

Open Door2No(0-9)
ENTER: _ PRESS #

OpenCCTV No (0-9)
ENTER: _ PRESS #

This No is used
Please try again

If relay 2 (door 2) is set for Mode 1
(door control), the display shows

proceed to step 5

if relay 2 is set for Mode 4 (CCTV
Switch), the display shows

Enter (0-9) then press # , the
display shows

proceed to step 5. If the number is
already used, the display shows

re-enter the number.

SELECT PROGRAM
ENTER: _ _ PRESS #

CloseCCTV No (0-9)
ENTER: _ PRESS #

This No is used
Please try again

SELECT PROGRAM
ENTER: _ _ PRESS #