Pach and Company AeGIS 9000 Series Manual User Manual

Page 18

FUNCTION CODE

LOCAL PROGRAMMING

LOCK OUT COUNT

(Default setting is 03 )

Minimum setting is 1 and Maximum

setting is 9 .

The system will ignore further

keypad code for 90 second if invalid

keypad code has been entered a

specific number of times.

Does not valid for card code or

combination between card code and

keypad code.

TONE OR PULSE

(Default setting is TONE)

If your local phone company does

not support tone dialing mode , you

must set the system for pulse dialing

mode. Most local phone companies

support tone dialing mode.

SINGLE OR MULTI SYSTEMS

(Default setting is SINGLE)

If more than one systems are on the
same phone line, you must set each

system to MULTI.

Step 4

Enter the unlock time value (04-99 Seconds) then press #, the display shows

Step 5

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function code 03, then press #, the display shows

Step 3

Enter the Lock Out Count value (1-9) then press #, the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function code 04, then press #, the display shows

Step 3

Enter 1 for Tone and 0 for Pulse then press # the display shows

Step 4

Select another Function Code to program different field from the table or
press * to exit the programming mode.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function code 05, then press #, the display shows

Step 3

Enter 1 for SINGLE or 0 for MULTI, then press #, the display shows

Pach and Company

Chapter 3

Page 10

AeGIS 9000 Series

PROGRAMMING

UNLOCK TIME, SEC
ENTER: 12 PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #

LOCK-OUT COUNT
ENTER: 3 PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #

TONE=1 PULSE=0
ENTER: 1 PRESS #

SELECT PROGRAM
ENTER: _ _ PRESS #

SINGLE=1 MULTI=0
ENTER: 1 PRESS #