Pach and Company AeGIS 9000 Series Manual User Manual

Page 32

FUNCTION CODE

LOCAL PROGRAMMING

MODIFY KEYPAD ACCESS CODE

AND CARD NUMBER (RADIO

TRANSMITTER NUMBER)

• You must know the keypad access

code to modify this field.

• The keypad access code cannot be

modified. You must delete it using

Function Code 32.

• Card number can be modified.

Step 1

Log on to programming mode (see section 3.1). The display shows

Step 2

Enter Function Code 31 then press # and the display shows

Step 3

Enter the 4-digit keypad access code to be modified then press #, the display
shows

if the keypad code is valid
and proceed to step 4

if the keypad code is
invalid, proceed to step 2 or
step 10

Step 4

Enter the card number or radio transmitter number (00001 - 65535) (leave
this field blank if no Card Reader installed on the system) then press #, the
display shows

if door 2 is set for mode 1 (door control). If door 2 is set other than mode 1,
proceed to step 6.

Step 5

Enter 1=Relay 1 (Door 1) , 2=Relay 2 (Door 2), 3=Both then press #, the
display shows

Step 6

Enter 1-3 then press #, the display shows

Step 7

Enter the Time Zone (s) programmed on Function Code 13 (0-9) then
press #, the display shows

Step 8

Enter 1=YES then press # and proceed to step 6 or 0=NO then press # and
the display shows

Step 9

Enter the name up to 12 characters then press #, the display shows

Pach and Company

Chapter 3

Page 24

AeGIS 9000 Series

PROGRAMMING

SELECT PROGRAM
ENTER: _ _ PRESS #

Access Code to
modify: _ _ _ _

CARD No:
ENTER: _ _ _ _ _ PRESS#

No such a CODE!
USE [30] TO ADD

Door 1 or Door 2
3 for both: _

TimeZone section
3 MAX [1-3]: _

Which Time Zone
[0-9] : _

Another sction
(1=YES) (0=NO): _

CODE HOLDER NAME
_ _ _ _ _ _ _ _ _ _ _ _

SELECT PROGRAM
ENTER: _ _ PRESS #