Control company – Control Company 4045 ALARM THERMOMETER User Manual

Page 2

Traceable

STAND
The unit is also supplied with a bench stand that is a part of the battery cover. To use the bench
stand, locate the small rectangular opening at the bottom of the unit. Place your fingernail into the
opening and flip the stand up. To close the stand, simply snap it shut.

ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, please replace the battery with a new
high quality battery (see “Battery Replacement” section). Low battery power can occasionally
cause any number of “apparent” operational difficulties. Replacing the battery with a new fresh
battery will solve most difficulties.

BATTERY REPLACEMENT
Erratic readings, a faint alarm, no alarm, a faint display, or no display are all indicators that the
battery must be replaced. To replace the battery, open the battery compartment door located on
the back of the unit (see Fig. 2). Remove the exhausted battery and replace it with a new AAA
alkaline 1.5 volt battery. Snap the battery compartment shut.

WARRANTY, SERVICE, OR RECALIBRATION

For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-

Certified by DNV and ISO 17025 accredited

as a Calibration Laboratory by A2LA.