beautypg.com

Control Company 4049 JUMBO DISPLAY DIAL THERMOMETER User Manual

Control company

background image

Traceable

®

is a registered trademark of Control Company ©2008 Control Company. 92-4049-00 Rev. 4 071008

Specifications

Range:

–58.0 to 302.0 °F (–50.0 to 150.0 °C)

Accuracy:

Cat. No. 4049/4355: ±1.0°C between -20 and 100°C

Cat. No. 4374: ±0.3° between -20 and 100°C at tested points

Resolution:

0.1° above -20° and below 200° 1° below -20° and above 200°

Sampling Rate:

1 second

Stem Length:

5¼˝ (13.3 cm)

Stem Diameter:

0.15˝ (3.8 mm)

Overall Length:

6½˝ (16.5 cm)

Battery:

1.5 volt, G-13 size

Construction:

Stainless steel and plastic

Weight:

1 oz. (28 g)

Ultra™ Thermometer Accuracy
Ultra™ thermometers are tested at selected test points to be within tighter than normal tolerances to assist in providing improved accuracy. Other
points will not necessarily fall within the same accuracy as those found at the selected test points, but will be within an accuracy of ±0.2° between –
20 and 100°C.

Operation
Slide the ON/OFF switch to ON to turn the unit on. Slide the °C/°F switch to °F to display the temperature in Fahrenheit or °C to display the
temperature in Celsius. Insert the stem into the material to be measured. Slide the ON/OFF switch to OFF to turn the unit off. To conserve battery
life, always turn the unit off when not in use.

Battery Replacement
Erratic readings, a faint display, or no display are all indications that the battery must be replaced. To replace the battery, remove the battery cap
screw. Remove the battery cap by turning it in the direction of the arrow (counter clockwise). Remove the exhausted battery and replace it with a
new 1.5 volt size G-13 battery. Equivalent replacement batteries are: Ray-O-Vac RW42, Duracell D357, Eveready 357. Make certain that the
positive (+) side is facing you. Replace the battery cap. Replace the battery cap screw and tighten securely.







WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025

accredited as a Calibration Laboratory by A2LA.

TRACEABLE

®

JUMBO DISPLAY DIAL THERMOMETER INSTRUCTIONS