Control Company 4230 TRACEABLE-100° C PLATINUM FREEZER THERMOMETER User Manual

Control Company Thermometers

Traceable

SPECIFICATIONS

Range:

-100 to 199.9 °C

Resolution:

0.1°

Sensor:

Pt 100 (Platinum)

Sampling Rate: 2 times/second

OPERATION
1. Attach the temperature probe to the meter.

(The probe and meter connectors are keyed, do not insert the connector
incorrectly and force it.)

2. Slide the ON/OFF switch to ON to turn the meter on.

3. Insert the probe into the material to be measured and
read the display.

Do not expose the display to temperatures below -10 °C or above 45
°C as this may damage the display.

The probe and cable may be exposed to temperatures as low as -
100 °C; however, the probe cable may become brittle after prolonged
exposure to temperatures below -50 °C. Bending a brittle cable may
result in damage to the cable. When exposed to temperatures below
-50 °C, wait for the cable to reach ambient temperature before
bending.

4. Slide the ON/OFF switch to OFF to turn the meter off.
To conserve battery life, always turn the meter off when
not in use.

PROBE HOLDER
The probe holder allows the
probe to be held in position
while attached to beakers,
stainless steel cylinders,
vats, etc.. Pinch the ends
of the holder and place the
probe through the outer
hole in the top portion of
the holder and then through
the outer hole on the
bottom of the holder. When the ends of the holder are
released, the holder will expand to grab the probe
securely. Use the clip to attach the holder to the side wall
of a container. To remove the holder, pinch the ends of
the holder and remove the probe.

ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any
reason, replace the battery with a new high quality battery
(see the “Battery Replacement” section). Low battery
power can occasionally cause any number of “apparent”
operational difficulties. Replacing the battery with a new
fresh battery will solve most difficulties.

BATTERY REPLACEMENT
Erratic readings, a faint display, no display or “LO BAT”
appearing on the display are all indications that the
battery must be replaced. Remove the battery cover by
sliding it in the direction of the “open” arrows. Remove
the exhausted battery and replace with a new 9 volt
alkaline battery. Replace the battery cover.

ACCESSORIES

Cat. No. 4138 Easy-Use Accessory Adaptor
Allows the unit to be run off AC power for continuous use.

WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:

CONTROL COMPANY

4455 Rex Road

Friendswood, Texas 77546 USA

Ph. 281-482-1714 Fax 281-482-9448

E-mail [email protected]

www.control3.com

Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.

TRACEABLE

-100° C PLATINUM FREEZER THERMOMETER INSTRUCTIONS