Control Company 4372 FLIP-STICK THERMOMETER - Manual

CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 4272 / 4372
Traceable
®
Flip-Stick TM Thermometer Instructions
92-4272-00
Rev. 3 092506
Traceable® is a registered trademark of Control Company
© 2006 Control Company
TRACEABLE ® FLIP-STICK™ THERMOMETER INSTRUCTIONS
SPECIFICATIONS:
Display: ¾”
LCD
Range: –58 to 572 °F / –50 to 300 °C
Resolution: 0.1° from –20 to 200, 1° outside this range.
Accuracy: Cat. No. 4272 ±0.3°C at tested points
Cat. No. 4372 ±1.0°C
Sampling Rate: 1 second
Features: Moving
head with adjustable angle of 45/90/135/180°, stainless steel sensor probe, memory recall, temperature
(°F/°C) selectable, data hold/test function, low battery indicator, and 16” Lanyard
CONTROLS/INDICATORS
H/T - hold/test
F/C - temperature selection
MAX/MIN - Minimum and maximum temperature recorded.
ULTRA™ THERMOMETER ACCURACY
Ultra™ thermometers are tested at selected test points to be within tighter than normal tolerances to assist in providing improved ac-
curacy. Other points will not necessarily fall within the same accuracy as those found at the selected test points, but will be within an
accuracy of ±1.0°C.
OPERATION
1. Extend probe to 45/90/135/180° to switch on the unit.
2. Press F/C button to select the desired temperature units.
3. Press H/T button once “HOLD” flashes on the display to retain reading for
recording. Press H/T again to release and return display to current reading.
4. Press MAX/MIN button once. “MIN” sign displays which represents the minimum tem-perature tested. Press MAX/MIN button again.
“MAX” sign shows to indicate the maxi-mum temperature testing. Current reading will restore automatically after 3 seconds.
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any reason, replace the battery with a new high-quality battery (see “Battery Replacement”
section). Low battery power can occasionally cause any number of “apparent” operational difficulties. Replacing the battery with a new
fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display, no display, or a battery icon appearing on the display are all indicators that the battery must be
replaced. Slide the panel on the back of the unit in the direction of the arrow. Replace exhausted battery with a new alkaline AAA bat-
tery. Slide the battery compartment cover back into place. Replacement battery Cat. No. 1105.
WARRANTY, SERVICE OR RECALIBRATION
For warranty, service or recalibration contact: