Control Company 4082 MEMORY HUMIDITY/THERMOMETER METER - Manual (Page 2)

Traceable ® is a registered trademark of Control Company ©2008 Control Company. 92-4082-00 Rev. 1 052308
INSTALLING AND REPLACING THE BATTERY
The Thermo-Hygrometer uses two ‘AA’ size batteries. If the display becomes dim, removes
the exhausted batteries and follow these steps to install or replace the batteries:
1. Open the battery chamber cover on the back of the unit.
2. Insert the batteries as indicated by the polarity symbols (+ and —) marked inside the
battery compartment.
3. Replace the battery cover.
Notes:
After you install or replace the batteries, it takes time to reset both the temperature and
humidity data. The display will show “---” for 1 to 2 seconds, then shows the updated
temperature and humidity reading.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.