Nova-Tech CBC Series - Manual (Page 24)

© Adam Equipment Company 2009
22
• Press [U. Wt./Units] to scroll through the options.
“
EL on
”
Sets the backlight to be on at all times.
“
EL Au
”
Sets the backlight to operate automatically when a weight is
placed on the scale or a key is pressed.
“
EL OFF
”
Sets the backlight to be off.
• Press the [Tare] key to store the value or press the [Zero] key to
escape from this setting and return to weighing.
11.0 ERROR CODES
During the initial power-on testing or during operation, the scale may show an
error message. The meaning of the error messages is described below.
If an error message is shown, repeat the step that caused the message,
turning the balance on, carry out the calibration or other functions. If the error
message is still shown contact your dealer for further support.
ERROR CODE DESCRIPTION POSSIBLE CAUSES
Err 1 Time input error. Tried to set an illegal time, i.e. 26hours
Err 2 Date input error Tried to set an illegal date, i.e. 36
th
day
Err 4 Initial Zero is greater than
allowed (typically 4% of
the maximum capacity)
when power is turned on
or when the
[Zero] key is
pressed,
Weight is on the pan when turning the
scale on.
Excessive weight on the pan when
zeroing the scale.
Improper calibration of the scale.
Damaged load cell.
Damaged Electronics.
Err 6 A/D count is not correct
when turning the scale
on. Platform is not installed.
Damaged Load cell.
Damaged Electronics.