Nitek CAMUTP24 - Manual

Rev 071904
Limited Lifetime Warranty
NITEK warrants that this product is to be free from defects in materials
and workmanship, for the life of the product. The warranty given by NITEK
is in lieu of any other warranties, express or implied. NITEK assumes no
responsibility for damages or penalties incurred resulting from the use of
this product. NITEK's liability under any warranties shall be discharged
by replacing or repairing, at our option, the defective product. NITEK's
liability for any product shall not exceed a refund of the purchase price.
The warranty listed here is intended only as a summary of your full and
complete warranty. For a full and complete warranty of this product
contact NITEK.
CAMUTP24
Camera Surge Protection Panel for
video, RS422 and 24 volt power
NITEK
®
5410 Newport Drive, Suite 24 • Rolling Meadows, IL 60008
(800) 528-4343 • (847) 259-8900 • FAX (847) 259-1300
Internet: www.nitek.net • E-mail: [email protected]
The CAMUTP24 is designed to provide
multistage surge video protection for fixed and
PTZ cameras. It is ideally suited for outdoor cam-
eras which need extreme protection on all sig-
nal connections.
The CAMUTP24 provides a heavy
single point ground connection and can be in-
stalled in minutes. Proper installation is critical
to proper operation of the unit. Please read in-
stallation instructions completely and insure
good ground connections.
SPECIFICATION
Size 1.7"H x 4.3"W x 2.5"D
Power NONE REQUIRED
Requirements
Video Insertion <0.2dB
Loss
Impedance 50 or 75 ohms
Temperature -40C to +85C
Frequency DC to 10 MHz
2.5
4.3
1.7