Nitek VR124COAX - Manual

Model VR124COAX
Coax Video Router
Installation and
Operation Manual
Introduction
The VR124COAX Video Router is designed to greatly extend the distances to which IP Cameras can operate.
The VR124COAX Video Router consists of two units, a Control Unit and a Remote Unit. The Control Unit is installed at
the NVR/ IP Equipment side and the Remote Unit at the IP Camera side of the installation.
NITEK
R
POWER INPUT
12-24 AC/DC, 0-100 Hz
Class 2 only, 1 Amp max.
COMMERCIAL
CCTV PRODUCT
40FE
E325724
POWER
10/100 Data
Status
ETHERNET
COAX
LINK
Type
Speed Off 10 Mbs
LED Green 100 Mbs
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Speed Off 10 Mbs
LED Green 100 Mbs
Activity Off No Network
LED On Network Detected
Blinking Network Activity
Status Blinking Optimizing Link
LED On Link Established
Type On Remote Unit
LED Off Control Unit
Ground
Connection
FRONT BACK
Note: A sticker on the bottom of each unit identifies whether it is the Control Unit or the Remote Unit.
VR124COAX Video Router Installation Drawing
Install Network to VR124COAX and IP Cameras
Refer to the above diagram when installing. Use best industry practices and follow all local building codes.
1) Connect an earth ground to each unit before making any additional connections.
2) Connect a network cable from the security room or IP network equipment to the CONTROL unit.
3) Connect a coaxial cable between the CONTROL unit and the REMOTE Unit.
4) Connect a network cable from the REMOTE unit’s Ethernet jack to the IP camera.
5) Connect a Class 2 power transformer to the push in power connector of each VR124COAX units. The units require
24VAC or VDC @ 1 Amp. There is no polarity to these terminals.
Normal Operation
When power is applied to both units the Network LED’s will come on and the link status LED will blink for about 30 sec-
onds as the link is being optimized. When the link is stable the link status LED will remain “ON”. The data LED will blink
with network activity.
NVR
Power
Transformer
VR124COAX
Control Unit VR124COAX
Remote Unit
2,500 ft (800 m)
RG-59 or Better
IP Camera
Network Cable Network Cable
Power
Transformer
Ground
Wire
Ground
Wire
! The separate protective earthing terminal provided on this product shall be permanently connected to earth.
NITEK
®
De Schans 19-21 2a
8231 KA Lelystad
Tel: +31(0)320-2300005
Fax: +31(0)320-282186
E-mail: [email protected]
WWW.NITEK.NL
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: (847) 259-8900
Fax: (847) 259-1300
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
091509 681200102