Nitek VH3200 - Manual (Page 2)

Remove Front Install Cards
Powering the Hub
The VH3200 is powered from a 24VAC wall pack. It uses a maximum of 18VA so several units can be run from a
larger supply. Contact Nitek Tech Support for recommendations.
Installing Cards
Remove the front panel of the VH3200 by pulling on both front knobs. Insert a card between the card guides. Push
the card to the rear until it slides into the edge connector and the front of the card is flush with the front of the
VH3200. Replace the front panel and press the knobs in to lock it in place. Refer to the instruction sheet with each
card for setup of each card.
Troubleshooting
Problem Video inverted or rolling and unstable.
Fix/Cause • Reverse the wires of the twisted pair at either the transmitter or receiver.
Problem
No video out at the receiver.
Fix/Cause • Check to make sure that there is video in at the transmit end.
• Make sure that the pair of wires you are using is not open or shorted between the
transmit and receiver points.
• Check power to the receiver.
Problem
Ghost image at the receiver.
Fix/Cause • Bridge tap or “T” tap on the twisted pair video line. Remove tap.
For additional help with problems please call Nitek Tech Support at (800) 528-4343. Hours are from 8am to 5pm
Central Standard Time, Monday through Friday. We are always ready to help.
Limited Warranty
Nitek warranties that this unit will be free from defects in materials and/or workmanship. Defective units will be
repaired or replaced at our option within 2 years from the date of shipment. This warranty does not apply to units
abused through misuse or subjected to improper and/or excessive voltage, beyond our control.
For complete warranty details contact Nitek.
1.73
.8
8.6
19.0