Dixon Valve 100 TON RAM SEC03 External Swage Holedall with Jackscrews - Manual (Page 4)

100 Ton Ram Instruction Manual
1-1/4" through 4" Standard & Long Flanged Holedall Swaged Couplings using Collar with Jack Screws
customer service 800 • 355 • 1991
2 Section 3
Lubricate the outside of the ferrule with Crisco®
(recommended) or high viscosity oil or heavy duty
grease.
Assuring that the hose end is cut square, chamfer
the I.D. of the hose 1/8" at a 45° angle. This will aid
in stem insertion. If the hose is to be static
grounded, follow hose manufacturers procedure for
proper static grounding.
Lubricate the I.D. of the hose and the O.D. of the
stem with Dixon Coupling Lubricant or equivalent.
Insert the stem into the hose until the hose end
contacts the stem collar. Position the sight hole on
the ferrule so that this can be observed. After stem
insertion, slide the ferrule down until the turned-over
part of the ferrule contacts the stem collar.
5a
4
5b
3
Lubricate the I.D. of both die halves with Crisco®
(recommended) or high viscosity oil or heavy duty
grease.