Dixon Valve 50 TON RAM SEC01 Specifications - Manual (Page 4)

50 Ton Ram Instruction Manual
Specifications 2 Section 1
Specifications:
Net Weight 630 lbs., basic equipment only
Crated Weight 780 lbs.
Dimensions 53" long x 18" wide x 19" high
Crated Dimension 76" long x 40" wide x 48" high
Pump Motor Power Team PE554 1-1/8 H.P. Universal Motor;
12,000 RPM; 115V single phase, 60/50 cycle AC (not dual voltage);
25 Amp, lightweight “handle-top” housing
Motor Control “Run-Off-Remote” motor control switch; 25 Amp motor control relay
Cavity mounted in motor housing, hand held remote switch
Safety Valves Relief valve set at 10,000 PSI
Control Valve Built-in manually operated 4-way control valves with 3/8" NPT port
Gauge Calibrated 0-10,000 PSI
Reservoir Convenient mounting holes in base
Oil Delivery 650 cu. in/min. at 100 PSI
80 cu. in/min. at 1,000 PSI
70 cu. in/min. at 5,000 PSI
55 cu. in/min. at 10,000 PSI
Note: 2-stage pump provides fast, no load approach speed and then shifts into slow actuation
as the load is applied.
• Ram double acting (Power Team RD5513-B)
• 13-1/8" stroke
• 55 tons of push at 10,000 PSI
• 28 tons of pull at 10,000 PSI
Preparations:
Filling the Reservoir Before removing the filler plug, clean the area around the plug.
The pump is a precision built unit, so special care should be taken to preclude
foreign particles from entering the reservoir. With cylinder fully retracted, fill the
tank 1" to 1½" from the top. Replace the filler plug.
Approved Hydraulic Power Team 9637 Mobil DTE25 or equivalent.
Oils
Available Motor 220-440, etc. Also 1½ H.P. and 3 H.P.
Variations
Reservoir 5 gallon or 10 gallon reservoir available
Variations
The standard 1-1/8 H.P., 12,000 RPM, 115 volt motor and the 2½ gallon reservoir has proven highly successful.
Dixon feels it is the best design, and variations are available, although not neccessarily desirable.