Dixon Valve 50 TON RAM SEC04 External Swaged RST and GAS - Manual (Page 5)

50 Ton Ram Instruction Manual
RSTxxxNOS Stems with GASxxxxNOS Ferrules
customer service 800 • 355 • 1991
3 Section 4
Install appropriate size spacer ring over the threads
of the stem so that it contacts the ferrule. The
spacer rings are listed as follows:
Insert the stem into the pusher so that the spacer
ring just installed contacts the pusher.
Put the directional control lever in the “FORWARD”
position. Advance the cylinder forward until the end
of the ferrule is near the die opening. Using a
wooden board or metal pipe, lift the ferrule up. Jog
the cylinder by depressing and releasing the button
on the remote. This will allow the ferrule to enter the
die slowly without contacting the die face.
11
10
12
9
1½"
2"
3"
RST150SPACE
RST200SPACE
RST300SPACE
Depress and hold the button on the remote until the
pusher meets the die face. When the extension
contacts the die, release the button. Move the
directional control lever to the “NEUTRAL” position.
Note: The spacer ring will enter the die.
Note: If the gauge reads 10,000 PSI before swaging
is complete, stop. The ferrule or die used for that
hose end may be incorrect. Contact Dixon for
further assistance.
1½"
2"
3"
50TPUSH150
50TPUSH200
50TPUSH300