Diamond Products DZ-S2 User Manual
2shudwlqj lqvwuxfwlrqv 6sduh sduwv olvw
Table of contents
Document Outline
- 0.1 Introduction
- 0.2 Validity of this manual
- 0.3 Standards
- 0.4 Delimitation of the system
- 0.5 Table of contents
- 1 Safety instructions
- 1.1 Fundamentals
- 1.2 Before starting work
- 1.3 During sawing
- 1.4 After the work
- 2 Technical data
- 2.1 Dimensions
- 2.2 Measurements
- 3 Range of applications
- 3.1 Connectable units
- 3.2 Possible applications
- 4 Design and function
- 4.1 Wall sawing system design
- 4.2 Safety components
- 4.3 Rail system
- 4.4 Wall saw head design
- 4.5 Function
- 4.6 Controls and connections
- 4.7 Function (table)
- 5 Set-up
- 5.1 Initial start-up
- 5.2 Preparatory operations
- 5.3 Selecting the saw blade
- 5.4 Replacing saw motor
- 5.5 Mounting V-rails on concrete
- 5.6 Fitting wall saw head
- 5.7 Adjustment / Taking up play
- 5.8 Removing the slide guides
- 6 Anchoring saw blade for normal cutting
- 7 Anchoring saw blade for flush cutting
- 8 Connecting the drive units
- 9 Sawing
- 9.1 Before sawing
- 9.2 The first cut (precut)
- 9.3 After the first cut
- 9.4 Terminating the work
- 10 Troubleshooting
- 11 Maintenance
- 11.1 Maintenance table
- 11.2 Change prism guides
- 11.3 Change feed motor
- 11.4 Exchange swivelling motor
- 11.5 Change gear grease
- 11.6 Toothed belt tensioning
- 11.7 Tensioning the toothed belt
- 11.8 Exchanging toothed belt
- 11.9 Repair
- 12 Transport, taking out of service, storage, disposal
- 12.1 Transport
- 12.2 Taking out of service and storage
- 12.3 Disposal
- 13 Accessories
- 13.1 Accessories available to order
- 13.2 Hydraulic drive motors
- 14 Spare parts list
- 14.1 Ordering information