Apple Macintosh LC 575 - Manual (Page 12)

If you see a blinking question mark on the screen, you’ll need to
install system software in one of the following ways:
m If your computer came with a CD-ROM disc labeled CD Install
Me First, see the section of this manual titled “Using the CD
Install Me First Disc” for instructions on how to use the disc
to install system software.
m If your computer came with a set of floppy disks, go to the
chapter “Setting Up Your Macintosh System” in the Macintosh
User’s Guide for instructions on installing system software
from floppy disks. Make sure that the label on the
Install Me
First disk says it is for your Macintosh model.
Safety instructions
For your own safety and that of your equipment, always take the
following precautions.
Turn off the computer completely and disconnect the power plug
(by pulling the plug, not the cord) if any of the following
conditions exists:
m the power cord or plug becomes frayed or otherwise
damaged
m you spill something into the case
m your Macintosh is exposed to rain or any other excess
moisture
m your Macintosh has been dropped or the case has been
otherwise damaged
m you suspect that your Macintosh needs service or repair
m you want to clean the case (use only the recommended
procedure described below)
For additional safety:
m Replace the back panel of the computer, if you ever need to
remove it, before you use your computer.
m Never turn on your computer with any of the internal parts
removed.
6 Setting Up