Minuteman E28_E30_E33 (7062.12_.15_.18) - Manual (Page 7)

7
Safety information
Adapt driving habits to local conditi-
ons.
• The machine may be used only for
operation on flat floors with a maxi-
mum inclination of up to 2 %.
1.4 Maintenance instructions
• The daily and weekly maintenance
and repair task must be performed
by a qualified operator. For further
maintenance and repair work please
contact your local Minuteman ser-
vice center.
• Observe the maintenance activities
and intervals set out in the instruc-
tion manual.
• Maintenance and repair work may
be carried out only by means of ap-
propriate tools.
• Have the machine checked for safe
condition by an expert at regular in-
tervals (recommendation: at least
once yearly) as well as after modifi-
cations or repair.
• Spare parts have to equal the techni-
cal requirements as specified by the
manufacturer! Genuine spare parts
guarantee compliance with these re-
quirements.
• Switch off the engine and remove
the key before inspecting the machi-
ne or performing any maintenance
work.
• To prevent the machine from being
used by unauthorized persons, the
control key must be removed.
• When performing work at the electri-
cal system, be sure to disconnect the
battery plug.
• Make sure to protect the recovery
tank against accidental closing or til-
ting down before working in the area
of a lifted tank lid.
• Do not clean the electrical parts by
means of high-pressure cleaning
equipment.
• The use of aggressive detergents is
prohibited.
• Let the machine dry after cleaning.
Do not stroe the machine with liquid
remaining in the tanks
• All protective devices must be in pla-
ce before operating the machine.
1.5 Specific Hazards
Electric system
• Only use genuine fuses with speci-
fied ratings.
• In case of malfunction of the electric
system, shut the machine down im-
mediately and have it serviced.
• Only qualified personnel are authori-
sed to work on the electrical system
and only according to electro-techni-
cal rules.
• Inspect/check the electrical equip-
ment of the machine at regular inter-
valls.Clear up any defects
immediately, such as loose connec-
tions or damaged cables..
Battery
• Observe the operating instructions of
the battery manufacturer.
• Never place metal objects or tools on
batteries - short-circuit hazard!
• Due to alteration of the center of gra-
vity, only use batteries as released
and at the prescribed position only.
• Charge batteries only in areas with
sufficient ventilation. – Explosion ha-
zard!