Minuteman E Ride 21 - Manual (Page 34)

5-6
5.7 CLEANING THE DETERGENT
SOLUTION (OR WATER FOR
WASHING) FILTER
1. Ascertain that the wash-and-dry machine cannot
move autonomously.
2. By acting on the wash-and-dry machine controls,
lower the squeegee and the disc brush (or cylindrical
brushes), then rotate the ignition key on “0” and
extract it (see chapter Use).
3. Close the water/detergent solution flow tap (1,
Figure 5-7) by acting on the right side of the wash-
and-dry machine.
4. Unscrew and remove the filter transparent cover (2).
5. Remove the filter (3) from the transparent cover (4).
6. Clean the filter (3) and the transparent cover (4).
7. Replace the filter (3) in its transparent cover case (4).
8. Screw the filter transparent cover to its seat (2).
9. Open the tap (1).
10. Rotate the ignition key on “I” and wait for the
squeegee and disc brush (or cylindrical brushes)
lifting, then rotate the ignition key on “0” and extract it.